89
(4)
Checking Pattern Combination Length
You can check the total length of the pattern combination
by pressing on the pattern combination length key
indicated in the preview window.
Press the function switch key. Press the preview key and
the preview window will open.
(1) Function switch key
(2) Preview key
(3) Pattern combination length key
The readout of the total length is a theoretical value
and the actual length may vary depending on sewing
conditions.
For example, select pattern SE5 three times, and sew a
pattern combination.
If the actual length differs considerably from the readout,
measure the actual length and enter the nearest value by
pressing the “+” or “–” key.
In this case, the theoretical value is 48 mm. However, if
the actual length is 40 mm, enter 40 mm by pressing the
“–” key. Press the OK to register it.
(4) Actual length
(1) (2)
The readout is adjusted automatically when calculating
the length of other pattern combinations.
The message “Displays the length of the corrected
pattern.” appears to indicate that the displayed value is
adjusted already.
(3)
To Next Page
Loading...
