149
Cleaning the Inside of the Thread Guide
Clean the inside of the thread guide plate under the top
cover at least once a month.
1.
Remove the needle thread and remove the thread
guide plate by pulling it up.
(1) Thread guide plate
2.
Clean the area around and under the pre-tension leaf
with the lint brush.
(2) Pre-tension leaf
(3) Lint brush
3.
Set the thread guide plate on the machine. Push the
thread guide plate down to snap it in place.
(1) Thread guide plate
(1)
1.
2.
3.
(2)
NOTE:
Hold the tip of the pre-tension leaf softly and brush out
the dust.
(1)
(3)
(2)
(2)
To Next Page
Loading...
