27
Drawing Up the Bobbin Thread
After using auto thread cutting or threading the bobbin
holder, you can start sewing without drawing up the
bobbin thread.
However, you need to draw up the bobbin thread when
sewing gathering stitches, etc.
1.
Remove the bobbin. Insert the bobbin into the
bobbin holder again and rethread the bobbin holder
according to the instructions on page 23, but leave a
10 cm (4˝) tail of bobbin thread as shown.
(1) Bobbin thread
2.
Raise the presser foot. Hold the needle thread lightly
with your left hand.
(3) Needle thread
3.
Press the needle up/down button twice to lower and
raise the needle and pick up the bobbin thread.
(4) Needle up/down button
4.
Pull both threads 10 cm (4˝) under and behind the
presser foot.
1.
3.
4.
2.
(1)
(2)
(3)
NOTE:
Do not cut the bobbin thread with the thread cutter.
(2) Thread cutter
(4)
To Next Page
Loading...
