60
6.
7.
8.
7.
After you nish buttonhole sewing, push the
buttonhole lever up as far as it will go.
8.
Place a pin just below the bartack at each end to
prevent accidentally cutting the threads.
Cut the opening with the seam ripper.
Use a punch to open a keyhole buttonhole.
6.
The buttonhole is sewn automatically in the sequence
shown.
When the buttonhole is nished, the machine will
stop automatically with the needle in the up position.
Press the thread cutter button and remove the fabric.
Double Layer Buttonhole
To make a sturdy buttonhole, sew another layer of
buttonhole stitches over the previous stitches.
After the buttonhole is nished, simply start the machine
again.
Do not raise the foot or buttonhole lever.
Do not reselect the pattern.
NOTE:
Turn off “Thread Cut after Auto-Lock” option when you
make a double layer buttonhole (refer to page 143).
NOTE:
A punch is not included with this machine.
To Next Page
Loading...
