GPS Navigator J-NAV500
9
Automatic sequencing mode Function that automatically steps from one waypoint to the next
when the arrival perpendicular point has been detected.
Manual sequencing mode The unit sounds the arrival alarm and the operator will manually
press key to step to next leg in the route plan when it is safe to
do so.
Default value Factory set value
NMEA0183 National Marine Electrical Association 0183. Association es-
tablishing international standards for communications between
navigational equipment and the standard established by NMEA.
Master reset A function for clearing all settings and returning to the factory
set values (default values). Two types of master resets are pro-
vided. A soft reset clears all data except for waypoint and route
plan data. A hard reset clears all data.
Initialization It takes up to 20 minutes to GPS position fixing when it is used
for the first time or after a master reset has been performed.
This time can be reduced by entering initialization values such
as estimate position, time and antenna height.
To Next Page
Loading...
Need help?
General
