JRC J-NAV 500 User Manual

GPS Navigator J-NAV500
14
No. Name Function
Displays the menus for each display mode.Menu
Use this key to select to destination (see Section 4.9, “Navigation
using direct routes (GOTO).” This key function is available in the
following display modes:
[ POSITION ] , [ NAVIGATION ] , [ CDI ] and [ PLOT ] displays
GOTO
Registers the current position (buoy or fishing point) as a waypoint.
This key function is available in the following major display modes:
[ POSITION ] , [ NAVIGATION ] , [ CDI ] , [ PLOT ] and [ MOB ]
displays.
Event
Turns on the power.
• Press this key and the key to turn off the power.
• Press this key while holding down the
key to perform a
soft reset.
Soft reset: All registered data except waypoints and
route plan are set to the default Values (factory
settings).
Power
• Resets items before the dial was pressed.
• In the Select Mode display, press this key to return to the previous
display.
Clear
Adjusts contrast and brightness of the backlight. This key function
is available in all display modes.
Contrast
Man overboard (position where a person fell overboard). This key
function is available in all display modes. (To return to previous
display mode, press this key for 3 seconds.)
MOB
3
4
5
6
7
8
9

JRC J-NAV 500 Specifications

General

Brand	JRC
Model	J-NAV 500
Category	GPS
Language	English