GPS Navigator J-NAV500
42
(1) Press in the [ROUTE] display mode to display the [Route Menu].
(2) Turn to select [FOLLOW ROUTE] and press to confirm the selection. This action
displays the [FOLLOW ROUTE] display.
(3) Turn to select desired route plan number (04 for the example) and press .
(4) This action selects [SEQUENCE MODE].
(5) Turn to select one of the following and press .
•
Auto
: automatic step of waypoints
•
Manual
: manual step of waypoints
•
Off
: no route plan is set
(6) [DIRECTION] is now selected.
(7) Turn to select one of the following and press .
•
Forward
: Displays waypoints of the route plan in the order they were set
•
Reverse
: Displays waypoints of the route plan in the reverse order
(8) Turn to select values for [SET ARRIVAL DISTANCE] and press .
Setting range:
0.00 to 9.99 nm
The [Position] display mode is now displayed automatically.
4.10 Navigation according to route plans
Select the number of the route plan you wish to follow. When the number of the route plan has been
selected, perform the settings in the displays that appear.
For information on route plans, see Section 4.18, "Setting Route Plans."
Display example
[Route Plan] display mode
To Next Page
Loading...
Need help?
General
