JRC J-NAV 500 User Manual

GPS Navigator J-NAV500
55
4.18.1 Making route plan
The following displays are used for making route plans.
Display examples
(1) Press in the [ROUTE] display mode. This displays the [ROUTE MENU] .
(2) Turn to select [MAKE ROUTE] and press .
This displays the [ROUTE MENU] .
This displays the [MAKE ROUTE] display and the numbers that can be used for a new route
plan. (The display above shows that 02 and 04 are already taken.)
(3) Turn to select desired route plan number (01 in the example) and press .
The display title changes to [MAKE ROUTE #01] .
(4) Enter the origin of waypoint number 001 in the [FROM] field for the first route (LEG 001) of
route plan #01. (The name of route number 001 is shown in the display.)
(5) Enter the number of the next waypoint in the [TO] field.
The entries made for route (LEG 001) and the calculated bearing and distance between the two
waypoints are displayed.
• Press to end a route plan.
• To enter the next route (LEG 002 to), repeat steps (4) and (5).
You can use steps (4) and (5) to enter up to 20 routes consisting of up to 199 waypoints.
[Route Plan] display mode
Repeat

JRC J-NAV 500 Specifications

General

Brand	JRC
Model	J-NAV 500
Category	GPS
Language	English