Chapter 3 INSTALLATION OF THE DISPLAY UNIT
3.5 CONNECTING TO THE JRC'S GPS RECEIVER
3-9
3
NSTALLATION MANUAL
Setting of JMA-3300
Basically, no setting is required.
No special setting is required for the use.
However, to change the setting for selecting or restricting the sentences to be received,
change the setting as described in 4.8 "Communication Port Setting".
Note:
When replacing JRC's GPS receiver, initialize the GPS receiver.
For details of the initializing procedure, see "■ GPS Adjust" of section
"4.9.1 GPS SETTING".
NMEA0183 standard input/output sentences
Input sentences
$xxACK Acknowledgement alarm
$xxBWC Bearing and Distance to Waypoint
$xxCUR Water current layer
$xxGGA Global Positioning System Fix Data
$xxGLL Geographic Position - Latitude/Longitude
$xxGNS GNSS fix data
$xxMTW Water temperature
$xxMWD Wind direction and speed
$xxMWV Wind speed and angle
$xxRMA Recommended minimum specific LORAN-C data
$xxRMB Recommended Minimum Navigation Information
$xxRMC Recommended Minimum Specific GNSS Data
$xxROT Rate of turn
$xxRSA Rudder sensor angle
$xxTHS True heading and status
$xxVBW Dual ground/water speed
$xxVDM AIS VHF data-link message
$xxVDO AIS VHF Data-link Own-vessel report
$xxVTG Course Over Ground and Ground Speed
$xxZDA Time and date
To Next Page
Loading...
