CHAPTER 13
Removing Switch Components
•
Installing and Removing EX3200 and EX4200 Switch Hardware
Components on page 173
•
Removing a Power Supply from an EX3200 or EX4200 Switch on page 174
•
Removing a Fan Tray from an EX3200 or EX4200 Switch on page 176
•
Removing an Uplink Module from an EX3200 or EX4200 Switch on page 177
•
Removing a Transceiver from an EX Series Switch on page 179
•
Disconnecting a Fiber-Optic Cable from an EX Series Switch on page 181
•
Disconnecting a Virtual Chassis Cable from an EX4200 Switch on page 182
•
Replacing a Member Switch of a Virtual Chassis Configuration (CLI
Procedure) on page 183
Installing and Removing EX3200 and EX4200 Switch Hardware Components
The EX3200 and EX4200 switch chassis is a rigid sheet-metal structure that houses the
hardware components. The field-replaceable units (FRUs) in EX3200 and EX4200
switches are:
•
Power supply
•
Fan tray
•
Uplink module
•
SFP transceiver
•
SFP+ transceiver
•
XFP transceiver
The power supply, fan tray, uplink module, and transceivers are hot-removable and
hot-insertable: You can remove and replace them without powering off the switch or
disrupting switch functions.
To install a power supply in an EX3200 or EX4200 switch, follow instructions in “Installing
a Power Supply in an EX3200 or EX4200 Switch” on page 132. To remove a power supply
from an EX3200 or EX4200 switch, follow instructions in “Removing a Power Supply
from an EX3200 or EX4200 Switch” on page 174.
173Copyright © 2010, Juniper Networks, Inc.
To Next Page
