General Site Guidelines for EX Series Switches
Efficient switch operation requires proper site planning and maintenance and proper
layout of the equipment, rack or cabinet (if used), and wiring closet.
To plan and create an acceptable operating environment for your EX Series switch and
prevent environmentally caused equipment failures:
•
Keep the area around the chassis free from dust and conductive material, such as
metal flakes.
•
Follow prescribed airflow guidelines to ensure that the cooling system functions properly
and that exhaust from other equipment does not blow into the intake vents of the
switch.
•
Follow the prescribed ESD prevention procedures to avoid damaging the equipment.
Static discharge can cause components to fail completely or intermittently over time.
•
Install the switch in a secure area, so that only authorized personnel can access the
switch.
Related Topics Prevention of Electrostatic Discharge Damage on EX Series Switches on page 236•
• Clearance Requirements for Airflow and Hardware Maintenance for EX2200 Switches
• Clearance Requirements for Airflow and Hardware Maintenance for EX3200 and
EX4200 Switches on page 96
• Clearance Requirements for Airflow and Hardware Maintenance for EX4500 Switches
• Clearance Requirements for Airflow and Hardware Maintenance for an EX8208 Switch
• Clearance Requirements for Airflow and Hardware Maintenance for an EX8216 Switch
• Environmental Requirements and Specifications for EX Series Switches on page 90
Site Electrical Wiring Guidelines for EX Series Switches
Table 26 on page90 describes the factorsyou must consider while planning the electrical
wiring at your site.
WARNING: It is particularly important to provide a properly grounded and shielded
environment and to use electrical surge-suppression devices.
89Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Site Preparation
To Next Page
Loading...
Need help?
General
