Juniper EX9200

Table 3: EX9200-MPC
Junos OS
Release
RequiredDescriptionModel
15.1R3A modular line card that accepts any of the following Modular
Interface Cards (MICs):
•
EX9200-10XS-MIC
•
EX9200-20F-M-MIC
•
EX9200-40T-MIC
The MICS are separately orderable.
EX9200-MPC line card has slots on the faceplate in which you
can install the MICs. You can install them in the following
configurations:
•
One EX9200-10XS-MIC
•
One EX9200-20F-M-MIC
•
One EX9200-10XS-MIC and one EX9200-20F-M-MIC
•
Two EX9200-10XS-MICs
•
Two EX9200-20F-M-MICs
•
One EX9200-40T-MIC
You can transmit up to 130 gigabits of traffic through the line
card without packet drop.
EX9200-MPC
You can use the show version command to see the version of Junos OS for EX Series
switches loaded on the switch.
Line Card Components
The EX9200-MPC has:
•
Two slots that can accept any of the following MICs:
•
EX9200-10XS-MIC has ten 10-Gigabit Ethernet small form-factor pluggable plus
(SFP+) ports, each of which can house small form-factor pluggable plus (SFP+)
transceivers. The ports form one port group. The ports support 10GBASE-SR,
10GBASE-LR, 10GBASE-ER, and 10GBASE-ZR transceivers. The MIC is shipped with
10 dust covers for the 10 ports. See Figure 2 on page 4.
•
EX9200-20F-M-MIC has twenty 1-Gigabit Ethernet small form-factor pluggable
(SFP) ports, each of which can house small form-factor pluggable (SFP) transceivers.
The ports are divided into two port groups of ten ports each. The ports labeled
[0/2]/0 through [0/2]/8 and [1/3]/0 through [1/3]/8 form one port group and the
ports labeled [0/2]/1 through [0/2]/9 and [1/3]/1 through [1/3]/9 form another port
group. These ports support 1000BASE-T, 1000BASE-SX, 100BASE-FX, 1000BASE-LX,
1000BASE-BX-U, 1000BASE-BX-D, 100BASE-BX-U, 100BASE-BX-D, and
1000BASE-LH transceivers. The MIC is shipped with 20 dust covers for the 20 ports.
See Figure 3 on page 4.
Copyright © 2016, Juniper Networks, Inc.4
Hardware Topics for Aloha Line Card