group share 120 gigabits of bandwidth. Thus, you can transmit up to 120 gigabits of traffic
through a port group, without packet drop.
Related
Documentation
Line Card Model and Version Compatibility in an EX9200 Switch on page 35•
• Pluggable Transceivers Supported on EX9200 Switches on page 37
• Installing a Line Card in an EX9200 Switch
• Handling and Storing Line Cards in EX9200 Switches
EX9200-32XS Line Card
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that you can
install in the line card slots on the front of the switch chassis. Line cards are hot-insertable
and hot-removable: You can remove and replace them without powering off the switch
or disrupting switch functions.
This topic describes:
•
Line Card Models on page 27
•
Line Card Components on page 28
Line Card Models
Table 14 on page 27 shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.
Table 14: EX9200-32XS Line Card
Junos OS Release
RequiredDescriptionModel
12.3R2 or laterA line card with 32 10-Gigabit Ethernet small
form-factor pluggable plus (SFP+) ports, each of
which can house 10-gigabit small form-factor
pluggable plus (SFP+) transceivers
EX9200-32XS
See Figure 16 on page 27.
Figure 16: EX9200-32XS Line Card
3—1— LEDs for SFP+ portsEjector lever
4—2— SFP+ portsLine card LEDs
27Copyright © 2016, Juniper Networks, Inc.
Chapter 2: Updated Common EX9200 Topics
To Next Page
Loading...
Need help?
General
