Ensure that all of the line cards in a switch are supported in the Junos OS release that
you want to use.
Related
Documentation
EX9204 Switch Hardware Overview on page 69•
• EX9208 Switch Hardware Overview on page 81
• EX9214 Switch Hardware Overview on page 91
Pluggable Transceivers Supported on EX9200 Switches
The line cards in EX9200 switches support 1-gigabit Ethernet small form-factor pluggable
(SFP), 1-gigabit Fast Ethernet SFP, 10-gigabit small form-factor pluggable plus (SFP+),
40-gigabit quad small form-factor pluggable plus (QSFP+), and 100-gigabit C form-factor
pluggable (CFP) transceivers. This topic describes the optical interfaces supported for
those transceivers.
NOTE: We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
Your JTAC engineer might recommend that you check the third-party optic
or cable and potentially replace it with an equivalent Juniper Networks optic
or cable that is qualified for the device.
The Gigabit Ethernet SFP, SFP+, and QSFP+ transceivers and the 100GBASE-LR4 CFP
transceivers installed in EX9200 switches support digital optical monitoring (DOM): You
can view the diagnostic details for these transceivers by issuing the operational mode
CLI command show interfaces diagnostics optics.
The tables in this topic describe the optical interface support over single-mode fiber-optic
(SMF) and multimode fiber-optic (MMF) cables for SFP, SFP+, QSFP+, and CFP
transceivers:
•
Table 21 on page 38—Optical interface support for Gigabit Ethernet SFP transceivers.
•
Table 22 on page 49—Optical interface support for Fast Ethernet SFP transceivers.
•
Table 23 on page 52—Optical interface support for SFP+ transceivers.
•
Table 24 on page 57—Optical interface support for QSFP+ transceivers.
•
Table 25 on page 60—Optical interface support for CFP transceivers.
37Copyright © 2016, Juniper Networks, Inc.
Chapter 2: Updated Common EX9200 Topics
To Next Page
Loading...
Need help?
General
