Juniper EX9200 User Manual

Standards Supported by These Cables
The cables comply with the following standards:
•
SFP mechanical standard SFF-843—see ftp://ftp.seagate.com/sff/SFF-8431.PDF .
•
Electrical interface standard SFF-8432—see ftp://ftp.seagate.com/sff/SFF-8432.PDF .
•
SFP+ Multi-Source Alliance (MSA) standards
Related
Documentation
Pluggable Transceivers Supported on EX Series Switches•
• Installing a Transceiver in a Switch
• Removing a Transceiver from a Switch
Power Requirements for EX9200 Switch Components
Table 28 on page 67 lists the power requirements for different hardware components
of EX9200 switches.
Table 28: EX9200 Switch Component Power Requirements
Reserved Power (watt)Typical Power (watt)Component
•
EX9204 switch: 410 W
•
EX9208 switch: 560 W
•
EX9214 switch: 1670 W
•
EX9204 switch: 410 W
•
EX9208 switch: 560 W
•
EX9214 switch: 1290 W
Base system
•
EX9204 switch: 690 W
•
EX9208 switch: 800 W
•
EX9214 switch: 1910 W
•
EX9204 switch: 690 W
•
EX9208 switch: 800 W
•
EX9214 switch: 1530 W
Redundant system
150 W150 WSwitch Fabric module (SF
module)
90 W90 WRouting Engine module (RE
module)
610 W530 WEX9200-2C-8XS line card
520 W408 WEX9200-4QS line card
607 W511 WEX9200-6QS line card
534 W461 WEX9200-MPC line card
29.8 W29.8 WEX9200-10XS-MIC
37 W37 WEX9200-20F-M-MIC
41 W41 WEX9200-40T-MIC
67Copyright © 2016, Juniper Networks, Inc.
Chapter 2: Updated Common EX9200 Topics

Juniper EX9200 Specifications

General

Brand	Juniper
Model	EX9200
Category	Network Router
Language	English