Juniper EX9200

• Installing a Line Card in an EX9200 Switch
• Handling and Storing Line Cards in EX9200 Switches
EX9200-6QS Line Card
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that you
can install in the line card slots on the front of the switch chassis. Line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
This topic describes:
•
Line Card Models on page 34
•
Line Card Components on page 35
Line Card Models
Table 19 on page 34 shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.
Table 19: EX9200-6QS Line Card
Junos OS Release RequiredDescriptionModel
14.2R1 or later
CAUTION: Junos OS Release 14.2R1
supports the EX9200-6QS line card
except for one specific configuration.
See the Junos OS 14.2R2 Release
Notes for Known Issue PR1068396 to
determine whether that configuration
applies to your switch and which
release to use if the configuration does
apply.
A line card with six 40-Gigabit Ethernet
quad small form-factor pluggable plus
(QSFP+) ports, each of which can
house 40-gigabit quad small
form-factor pluggable plus (QSFP+)
transceivers and 24 10-Gigabit Ethernet
small form-factor pluggable plus
(SFP+) ports, each of which can house
10-gigabit small form-factor pluggable
(SFP+) transceivers
EX9200-6QS
See Figure 21 on page 34.
Figure 21: EX9200-6QS Line Card
4—1— SFP portsEjector lever
5—2— LEDs for QSFP+ portsLine card LED
6—3— QSFP portsLEDs for SFP+ ports
Copyright © 2016, Juniper Networks, Inc.34
Hardware Topics for Aloha Line Card