8. Place the MIC in an antistatic bag or on its own antistatic mat placed on a flat, stable
surface.
9. If you are not installing a MIC in the emptied MIC slot within a short time, install a blank
cover panel over the slot and secure it with captive screws by using the screwdriver.
Do this to protect the interior of the line card and the switch chassis from dust or other
foreign substances and to ensure that the airflow inside the line card and the switch
chassis is not disrupted.
Figure 9: Removing an EX9200-10XS-MIC or EX9200-20F-M-MIC
13Copyright © 2016, Juniper Networks, Inc.
Chapter 1: New Topics
To Next Page
Loading...
Need help?
General
