Juniper EX9200 User Manual

EX9200-40F-M Line Card
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that you
can install in the line card slots on the front of the switch chassis. Line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
This topic describes:
•
Line Card Models on page 30
•
Line Card Components on page 31
Line Card Models
Table 16 on page 30 shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.
Table 16: EX9200-40F-M Line Card
Junos OS Release
RequiredDescriptionModel
14.2R1 or laterA line card with 40 1-Gigabit Ethernet small
form-factor pluggable (SFP) ports with Media Access
Control Security (MACsec) capability, each of which
can house 1-gigabit small form-factor pluggable
(SFP) transceivers
EX9200-40F-M
See Figure 18 on page 30.
Figure 18: EX9200-40F-M Line Card
4—1— LEDs for SFP portsEjector lever
5—2— SFP ports with MACsec capabilityLine card LED
3—MIC LED
You can use the show version command to see the version of Junos OS for EX Series
switches loaded on the switch.
Copyright © 2016, Juniper Networks, Inc.30
Hardware Topics for Aloha Line Card

Juniper EX9200 Specifications

General

Brand	Juniper
Model	EX9200
Category	Network Router
Language	English