CAUTION: Before you slide the MIC into the slot, ensure that the MIC is
aligned correctly. Misalignment might cause the pins to bend, making the
MIC unusable.
7. Slide the MIC into the slot gently until it is fully seated (see Figure 7 on page 10 or
Figure 8 on page 11).
8. Push the MIC ejector lever on the line card that is adjacent to the MIC slot in which
you are installing the MIC until the MIC is seated properly.
9. If you are installing only one EX9200-10XS-MIC or EX9200-20F-M-MIC, install a blank
cover panel over the empty MIC slot and secure it with captive screws by using the
screwdriver. Do this to protect the interior of the chassis from dust or other foreign
substances and to ensure that the airflow inside the chassis is not disrupted.
10. Bring the MIC online by pressing the online/offline button on the MIC by using a pin
that fits the opening to the button until the OK/FAIL LED on the MIC is lit green. You
can also bring the MIC online by issuing the following CLI command:
user@host> request chassis mic fpc-slot slot-number mic-slot slot-number online
9Copyright © 2016, Juniper Networks, Inc.
Chapter 1: New Topics
To Next Page
Loading...
Need help?
General
