Juniper SRX550 - Table 53: Default Interface Configuration for the Services Gateway

Table 53: Default Interface Configuration for the Services Gateway
Address
DHCP
State
Security
ZoneConnectorInterfacePort Label
Dynamically assignedClientUntrustRJ-45ge-0/0/0
NOTE: If
chassis
clustering is
enabled, use
this port as
the
management
port (fxp0).
0/0
192.168.1.1/24ServerTrustRJ-45ge-0/0/1 (if
used)
NOTE: If
chassis
clustering is
enabled, use
this port as
the control
port (fxp1).
0/1
192.168.2.1/24ServerTrustRJ-45ge-0/0/2 (if
used)
NOTE: Use
this port as a
fabric port.
0/2
192.168.3.1/24ServerTrustRJ-45ge-0/0/3 (if
used)
NOTE: Use
this port as a
fabric port.
0/3
125Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Performing Initial Configuration