Juniper SRX550 - Chapter 24 Replacing Gigabit-Backplane Physical Interface Modules; Replacing Gigabit-Backplane Physical Interface Modules on the SRX550 High Memory Services Gateway; Removing a Gigabit-Backplane Physical Interface Module; Table 63: LED Indications for Hot-Swappable GPIM Components

CHAPTER 24
Replacing Gigabit-Backplane Physical
Interface Modules
•
Replacing Gigabit-Backplane Physical Interface Modules on the SRX550 High Memory
Services Gateway on page 175
Replacing Gigabit-Backplane Physical Interface Modules on the SRX550 High Memory
Services Gateway
•
Removing a Gigabit-Backplane Physical Interface Module on page 175
•
Installing a Gigabit-Backplane Physical Interface Module on page 176
•
Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate on page 177
•
Installing a Blank Gigabit-Backplane Physical Interface Module Faceplate on page 178
Removing a Gigabit-Backplane Physical Interface Module
To remove a GPIM from the services gateway:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2. Push the OFFLINE button to turn the GPIM offline. After the STATUS LED light turns
off, it is safe to remove the GPIM. See Table 63 on page 175 for a description of LED
indications for hot-swappable GPIM components.
Table 63: LED Indications for Hot-Swappable GPIM Components
DescriptionComponentNumber
The STATUS LED has the following indicators:
•
Solid green indicates that the GPIM is functioning normally.
•
Solid yellow indicates that the GPIM is starting up, running
diagnostics, or going offline.
•
Solid red indicates that the GPIM has failed.
•
Off indicates that the GPIM is not powered on, is offline,
or is not configured.
STATUS LED1
Push the button to turn the GPIM offline. After the STATUS
LED light goes off, it is safe to remove the GPIM from the
services gateway.
ONLINE/OFFLINE
button
2
175Copyright © 2016, Juniper Networks, Inc.