CHAPTER 23
Replacing Mini-Physical Interface Modules
•
Replacing Mini-Physical Interface Modules on the SRX550 High Memory Services
Gateway on page 171
Replacing Mini-Physical Interface Modules on the SRX550 High Memory Services
Gateway
Before you begin, power off the services gateway.
CAUTION: The Mini-Physical Interface Modules (Mini-PIMs) available are
not hot-swappable. You must power off the servicesgatewaybeforeremoving
or installing Mini-PIMs.
To maintain proper airflow through the services gateway, cover any empty Mini-PIM slot
with a blank faceplate.
CAUTION: Do not remove a blank faceplate unless you are installing a
Mini-PIM in the empty slot.
•
Removing a Mini-Physical Interface Module on page 171
•
Installing a Mini-Physical Interface Module on page 172
•
Removing a Blank Mini-Physical Interface Module Faceplate on page 173
•
Installing a Blank Mini-Physical Interface Module Faceplate on page 173
Removing a Mini-Physical Interface Module
To remove a Mini-PIM from the services gateway:
1. Place an electrostatic bag or antistatic mat on a flat, stable surface on which you
intend to place the Mini-PIM.
2. Attach an ESD grounding strap to your bare wrist, and connect the strap to the
grounding point on the back of the device.
3. Unplug the power adapter from the services gateway. Verify that the Power LED is
off.
171Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
