Installing a Blank Gigabit-Backplane Physical Interface Module Faceplate
To maintain proper airflow through the services gateway, install blank faceplates in slots
that do not contain Gigabit-Backplane Physical Interface Modules (GPIMs).
To install a blank faceplate:
1. Align the captive screws on the blank faceplate with the screw holes on the chassis.
2. Using a Phillips (+) screwdriver, tighten the captive screws on each side of the blank
faceplate until the faceplate is flush with the chassis.
Related
Documentation
• Replacing Mini-Physical Interface Modules on the SRX550 High Memory Services
Gateway on page 171
Copyright © 2016, Juniper Networks, Inc.178
SRX550 High Memory Services Gateway Hardware Guide
To Next Page
Loading...
