8-Port Gigabit Ethernet SFP XPIM Components
The 8-Port Gigabit Ethernet small form-factor pluggable Gigabit-Backplane Physical
Interface Module (SFP XPIM) contains the components listed in Table 9 on page 26.
Table 9: 8-Port Gigabit Ethernet SFP XPIM Components
DescriptionLocationComponent
Use the ONLINE/OFFLINE button to
gracefully shut down the XPIM. Press and
hold the button for 4 to 5 seconds, and
then release. The XPIM gracefully shuts
down and turns off the power supply units
(PSUs).
To power up the XPIM (if the Services and
Routing Engine [SRE] is off), press and
hold the ONLINE/OFFLINE button for 4 to
5 seconds.
Right side of the XPIMONLINE/OFFLINE button
Use the captive screws to hold the XPIM
in place.
One on each side of
the XPIM
Two captive screws
8-Port Gigabit Ethernet SFP XPIM Hardware Specifications
Table 10 on page 26 provides the physical specifications of the 8-Port Gigabit Ethernet
small form-factor pluggable XPIM (SFP XPIM).
Table 10: 8-Port Gigabit Ethernet SFP XPIM Physical Specifications
ValueDescription
0.78 in. x 6.72 in. x 8.1 in.
(1.98 cm x 17.1 cm x 20.57 cm)
Dimensions (H x W x L)
17.6 oz (0.499 kg)Weight
SFPConnector type
XPIMForm factor
32° F through 104° F (0° C through 40° C)Environmental operating temperature
5% to 90% noncondensingRelative humidity
Up to 10,000 ft (3000 m)Altitude
8-Port Gigabit Ethernet SFP XPIM LEDs
The 8-Port Gigabit Ethernet small form-factor pluggable XPIM (SFP XPIM) has two LEDs
for each port — LINK and ACT. Each XPIM has a STATUS LED, which indicates the status
of the XPIM. The LEDs are listed in Table 11 on page 27.
Copyright © 2016, Juniper Networks, Inc.26
SRX550 High Memory Services Gateway Hardware Guide
To Next Page
Loading...
