Table 56: Factory-Default Settings-Interfaces (continued)
IP AddressDHCP StateSecurity ZoneInterfacePort Label
192.168.3.1/24Servertrustge-0/0/30/3
192.168.4.1/24Servertrustge-0/0/40/4
192.168.5.1/24Servertrustge-0/0/50/5
Verify the Settings
Launch a Web browser from the management device and access the services gateway
using the URL http://192.168.1.1 (if connected to port 0/1). For ports other than 0/1, access
the services gateway using the URL http://192.168.x.1, where x is the port number. Refer
to Table 56 on page 130. The J-Web login page is displayed. This indicates that you have
successfully completed the initial configuration and that your SRX550 High Memory
Services Gateway is ready for use.
If the page does not load, perform the following checks to see if you can identify the
problem:
•
Check if the cable connecting the ISP-supplied device to the SRX Series device is firmly
seated.
•
Use the CLI ping command to verify that the SRX550 High Memory Services Gateway
can be accessed from the management device.
•
Check if the Ethernet port has acquired the IP address on the correct sub-network.
•
Clear the browser cache on the management device.
With this step, you have successfully completed the initial configuration, and your SRX550
High Memory Services Gateway is ready for use. You can proceed with customizing the
configuration according to your requirements.
Related
Documentation
Configuring the SRX550 High Memory Services Gateway Using the CLI on page 134•
Connecting to the SRX550 High Memory Services Gateway from the CLI Locally
To use the CLI to configure the SRX550 High Memory ServicesGateway, you must connect
through the console port, as shown in Figure 28 on page 132.
131Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Performing Initial Configuration
To Next Page
Loading...
