set security zones security-zone trust interfaces t1-1/0/0.0 host-inbound-traffic
system-services all
For E1 interfaces:
set security zones security-zone trust interfaces e1-1/0/0.0 host-inbound-traffic
system-services all
For the 1-Port Serial Mini-PIM:
set security zones security-zone trust interfaces se-1/0/0.0 host-inbound-traffic
system-services all
5. Add or select security zones for host inbound traffic protocol options:
For T1 interfaces:
set security zones security-zone trust interfaces t1-1/0/0.0 host-inbound-traffic protocols
all
For E1 interfaces:
set security zones security-zone trust interfaces e1-1/0/0.0 host-inbound-traffic protocols
all
For the 1-Port Serial Mini-PIM:
set security zones security-zone trust interfaces se-1/0/0.0 host-inbound-traffic protocols
all
6. Set security policies:
set security policies default-policy permit-all
NOTE: You can use the CLI commands set interfaces t1–1/0/0 or set interfaces
e1–1/0/0 to enable the 1-Port T1/E1 Mini-PIM to function as a T1 or an E1
interface.
Related
Documentation
• SRX550 High Memory Services Gateway Mini-Physical Interface Modules Overview
on page 31
• 1-Port Serial Mini-Physical (SRX-MP-1SERIAL-R) Interface Module on page 32
• 1-Port T1/E1 Mini-Physical (SRX-MP-1T1E1-R) Interface Module on page 34
139Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Performing Initial Configuration
To Next Page
Loading...
