Chapter 2. Installing and Using RF ValProbe Software
22 RF ValProbe® User’s Manual
2.3.1a Setting up Site Options (cont.)
• Disable user accounts after 3 unsuccessful login attempts. This option will disable a
user account if there are three consecutive PC login failures for the same user ID. If a
user's account is disabled, the System Administrator must enable the account and
assign a new temporary password. This option does not affect logins from the RF
ValProbe instrument panel.
• Display User ID during entry. By default, the user ID is shown to the user when
logging in. Clearing this option will replace the user ID characters with asterisks
(*****).
• Allow Operators to change Preferences. Preferences are workstation defaults that
specify the temperature units (Celsius or Fahrenheit), the COM port, and when to
issue low battery warnings. Any changes made to the system preferences are effective
immediately, and all setups created after the preferences have been changed will
reflect these new settings. If this option is not enabled, the System Administrator is
responsible for changing preferences
• Disable the password system. User IDs and passwords will not be required to use the
software.
Note: If you select this option, the Kaye RF ValProbe system will not enable compliance
with 21CFR Part 11 requirements for electronic records.
Click the check box next to any option that you want to enable. An X appears in the check
box when the option is enabled. Click the check box again if you want to disable it. The
check box will be blank. Once your site options have been set, click on the Preferences
tab.
To Next Page
Loading...