Chapter 1. Setting Up the RF ValProbe
RF ValProbe® User’s Manual 7
1.1.6 The Logger Batteries
The Logger is powered by two 1.5 V, AA lithium batteries (Kaye #200-084), shipped with
the Logger. To replace the batteries, first shut off the Logger by sliding the power switch
(shown in Figure 4 below) to the left. Then open the sliding panel on the back of the
Logger and replace the batteries in the compartment shown in Figure 4 below. Do not turn
the Logger back on (sliding the power switch to the right) until you have replaced the
compartment cover.
CAUTION!
If it becomes necessary to replace a Logger battery, use only a Kaye
#200-084 1.5 V lithium battery. Use of any other battery will void your
Logger warranty.
Figure 4: Logger Battery Compartment, Power Switch and Network ID Wheel
To Next Page
Loading...