Kaye RF ValProbe - Installation for a Standalone Application

To Next Page

To Previous Page

Chapter 2. Installing and Using RF ValProbe Software

24 RF ValProbe® User’s Manual

2.3.2 Installation for a Standalone Application

1. Insert the RF ValProbe CD into your CD-ROM drive.

2. If the installation does not automatically begin, complete the following steps:

• Click Start on the Windows task bar, and then click Run.

• Click Browse. From the Browse dialog box, select your CD-ROM drive, click

Setup.exe, and then click Open.

3. Click on the appropriate installation path to install Kaye RF ValProbe to your PC.

4. Follow the on-screen instructions to perform the installation.

5. Once installation has completed, the Kaye RF ValProbe Initialization program will run

automatically. The Kaye RF ValProbe splash screen will appear, followed by the two

System Administrator Site Options screens -- Policies and Preferences. Select the

desired Site Options (as discussed on page 21 through page 23), and click

OK.

6. Click

Finish to complete the initialization program.

7. Return to the Windows task bar.

8. Click

Start, then Programs, then Kaye RF ValProbe, and then Client Setup.

9. Click on the appropriate installation path to install the client to your PC.

10. Follow the on-screen instructions to finish the installation.