Chapter 2. Installing and Using RF ValProbe Software
RF ValProbe® User’s Manual 41
2.5.2 Setting Up the Ethernet Connection (cont.)
c. Users can either accept the network ID programmed into the Base Station or enter a
new Network ID, from 0 to 9, or A to F. (The default ID is 0.)
• To obtain the programmed ID, click on the Get Network ID button. The software
obtains the programmed ID from the Base Station.
• To enter a Network ID, use the arrow keys next to the text box.
d. Click
OK to confirm the settings and return to the Preferences screen.
Note: Be sure that the ID number at the back of each Logger matches the network ID
number programmed in this window.
If you want to return to USB operation, click the
Switch to USB button while the Ethernet
cable remains plugged into the Base Station. Then follow the on-screen instructions.
To Next Page
Loading...