Keithley 6514

F IEEE-488 Bus Overview
Introduction ............................................................................... F-2
Bus description .......................................................................... F-3
Bus lines .................................................................................... F-5
Data lines ............................................................................ F-5
Bus management lines ........................................................ F-5
Handshake lines .................................................................. F-6
Bus commands ........................................................................... F-7
Uniline commands .............................................................. F-8
Universal multiline commands ........................................... F-8
Addressed multiline commands ......................................... F-9
Address commands ............................................................ F-9
Unaddress commands ......................................................... F-9
Common commands ......................................................... F-10
SCPI commands ............................................................... F-10
Command codes ............................................................... F-10
Typical command sequences ............................................ F-11
IEEE command groups ..................................................... F-12
Interface function codes .......................................................... F-13
G IEEE-488 and SCPI Conformance Information
Introduction ............................................................................... G-2
H Calibration Options
Introduction ............................................................................... H-2
Reading calibration standard values .......................................... H-2
Data transfer connections ................................................... H-2
Reading values ................................................................... H-2
Example program ............................................................... H-3
Remote calibration ..................................................................... H-4
Calibration commands ........................................................ H-4
Remote calibration overview .............................................. H-4