Keithley 6514

13-20 Status Structure
Programming example — read error queue
The following command reads the error queue:
STAT:QUE? ‘ Read Error Queue.
Table 13-7
SCPI commands — error queue
Command Description Default
STATus STATus subsystem:
:QUEue Read error queue: (Note 1)
[:NEXT]? Read and clear oldest error/status (code and message).
:ENABle <list> Specify error and status messages for error queue. (Note 2)
:ENABle? Read the enabled messages.
:DISable <list> Specify messages not to be placed in queue. (Note 2)
:DISable? Read the disabled messages.
:CLEar Clear messages from error queue.
SYSTem SYSTem subsystem:
:ERRor Read error queue: (Note 1)
[:NEXT]? Read and clear oldest error/status (code and message).
:ALL? Read and clear all errors/status (code and message).
:COUNt? Read the number of messages in queue.
:CODE Code numbers only:
[:NEXT]? Read and clear oldest error/status (code only).
:ALL? Read and clear all errors/status (codes only).
:CLEar Clear messages from error queue.
Notes:
1. Power-up and *CLS empties the error queue. STATus:PRESet has no effect.
2. Power-up enables error messages and disables status messages. *CLS and STATus:PRESet have no effect.