Keithley 6514

List of Tables
1 Getting Started
Table 1-1 SCPI commands - line frequency ........................................ 1-10
Table 1-2 Default settings .................................................................... 1-13
2 Measurement Concepts
Table 2-1 Basic measurement capabilities ............................................. 2-2
Table 2-2 SCPI commands — autozero ................................................. 2-3
Table 2-3 Display messages for zero check and zero correct .............. 2-13
Table 2-4 SCPI commands — zero check and zero correct ................. 2-15
Table 2-5 SCPI commands — input bias current and offset
voltage calibration .......................................................... 2-18
Table 2-6 Summary of measurement considerations ........................... 2-19
3Volts and Ohms Measurements
Table 3-1 SCPI commands — volts and ohms function ........................ 3-7
4 Amps Measurements
Table 4-1 SCPI commands — amps function ........................................ 4-8
Table 4-2 Minimum recommended source resistance values .............. 4-11
5 Coulombs Measurements
Table 5-1 SCPI commands — coulombs function ................................. 5-5
6 Range, Units, Digits, Rate, and Filters
Table 6-1 Measurement ranges .............................................................. 6-2
Table 6-2 SCPI commands — range and digits ..................................... 6-4
Table 6-3 SCPI commands — rate ......................................................... 6-7
Table 6-4 SCPI commands — filters ................................................... 6-10
7 Relative, mX+b and Percent (%)
Table 7-1 Range symbols for rel values ................................................. 7-3
Table 7-2 SCPI commands — relative (null) ......................................... 7-3
Table 7-3 SCPI commands — mX+b and percent ................................. 7-6
8 Buffer
Table 8-1 SCPI commands — buffer ..................................................... 8-4