DDC Emulation Commands D-5
A. The hit key command (Hn) is not used by the Models 6512, 617, and 617 HIQ. The hit command is similar to the SCPI
SYSTem:KEY command (see Section 16 for details).
B. The buffer size command (In) is not used by the Models 6512, 617, and 617 HIQ. The buffer size command is similar to the SCPI
TRACe:POINts command (see Section 8 for details).
C. The moving filter cannot be selected from the DDC language.
D. For the Models 6512, 617, and 617 HIQ, the terminator commands (Y) to set the terminator are different from the Y commands
used by the Models 6512, 617, and 617 HIQ. Also note that the “YY” response to the U0 command is different.
E. For the Model 6514, the Buffer Full bit in the U2X status word does not get cleared until either the buffer is resized or buffer stor-
age is reactivated. Note that requesting a buffer reading does not clear the U2 Buffer Full bit.
F. The U3 status command is not used by the Models 6512, 617, and 617 HIQ. The response message indicates the buffer size (In)
and the actual number of readings stored in the buffer.
Mode Command Description Note
Terminator
Zero Correct
Y0
Y1
Y2
Y3
Y4
Z0
Z1
LFCR (line feed, carriage return)
CRLF (carriage return, line feed)
LF (line feed)
CR (carriage return)
None
Zero Correct disabled
Zero Correct enabled
D
Table D-1 (cont.)
Device dependent command summary
To Next Page
Loading...
Need help?
General
