Keithley 6514 User Manual

N
Noise 4-10
Non-decade current gains 11-16
Non-standard coulombs ranges 11-13
O
Offset voltage calibration 18-9
Ohms calibration 19-16
Ohms measurement accuracy 18-15
One-shot triggering E-3
Options and accessories 1-3
Output queue 13-18
Output trigger specifications 9-12
Overview 13-2
P
Percent (%) 7-5
Perform limit tests 10-11
Performance considerations 2-2
Performance Verification 18-1
Performing the verification test
procedures 18-8
Piezoelectric and stored charge effects C-3
Power-up 1-10
Power-up sequence 1-11
Preparing for calibration 19-7
Primary address selection 12-7
Programming and reading registers 13-5
Programming enable registers 13-5
Programming example 3-8, 4-9, 5-6, 8-6,
9-10, 10-15
Programming examples E-2
Programming syntax 12-11
Q
Queues 13-18
R
Range 6-2
Range, units, and digits 6-2
Range, Units, Digits, Rate, and Filters 6-1
Rate 6-6
Reading calibration standard values H-2
Reading registers 13-6
Reading values H-2
Rear panel summary 1-8
Recalculating resistance reading limits 18-6
Recall 8-2
Recommended calibration equipment 19-3
Recommended test equipment 18-4
Register bit descriptions 13-11
Relative 7-1, 7-2
Relative, mX+b and Percent (%) 7-1
Remote calibration H-4
Remote calibration overview H-4
Remote Operation 12-1
Resetting the calibration code 19-19
Restoring factory defaults 18-9
Routine Maintenance 20-1
RS-232 connections 12-18
RS-232 interface reference 12-17
RS-232 settings 12-17
S
Safety symbols and terms 1-2
SCPI commands F-10
SCPI programming 1-15, 2-3, 2-18, 3-7, 4-8,
5-5, 8-4, 9-9, 10-12
SCPI programming — digital output
pattern 11-6
SCPI programming — external feedback 11-17
SCPI programming — filters 6-10
SCPI programming — mX+b and percent 7-6
SCPI programming — range and digits 6-4
SCPI programming — rate 6-7
SCPI programming — relative 7-3
SCPI programming — zero check and zero
correct 2-15
SCPI Reference Tables 17-1
SCPI Signal Oriented Measurement
Commands 15-1
Selecting and configuring an interface 12-2
Sending and receiving data 12-17
Serial polling and SRQ 13-9
Service request enable register 13-8
Setting and controlling relative 7-2
Setting digital output lines 11-5
Setting line voltage and replacing line fuse 20-2
Shielded fixture construction 11-12
Sink mode — controlling external devices 11-3
Source mode — logic control 11-5
Specifications A-1
Status and Error Messages 1-12, B-1
Status byte and service request (SRQ) 13-7
Status byte and service request commands 13-9

Keithley 6514 Specifications

General

Brand	Keithley
Model	6514
Category	Measuring Instruments
Language	English