AEJ-C/AES-C/PLJ-C-BA-e-1621 101
After setting the limit values, the weighing balance will be ready for check
weighing.
Tare, as required, place the load on the weighing pan and start tolerance
control.
The indicators <MIN>, <OK> or< MAX> will show the sample weight in relation
to the tolerance limits.
Sample display State
Load below set tolerance
Load within set tolerance
Load above set tolerance
• The limit values will be saved until new values are defined
• To delete limit values, set value to [0.000 g]
• Return to weighing mode, see chap. 17.2.1
To Next Page
Loading...
