SYSTem:COMMunicate:LAN:IPADdress "<address>"
SYSTem:COMMunicate:LAN:IPADdress? [{CURRent|STATic}]
Assigns a static Internet Protocol (IP) address for the instrument. If DHCP is enabled (SYSTem:COMMu-
nicate:LAN:DHCP ON), the specified static IP address is not used. Contact your LAN administrator for details.
If you change this setting, you must execute a SYSTem:COMMunicate:LAN:UPDate command to activ-
ate the setting.
Parameter Typical return
<address> = Four-byte dot notation ("nnn.nnn.nnn.nnn"), where "nnn" in each case is a byte
value in the range 0 through 255.
[{CURRent | STATic}] Default: CURRent
"198.105.232.4"
Sets a static IPaddress:
SYST:COMM:LAN:IPAD "198.105.232.4"
SYST:COMM:LAN:UPD
– CURRent - Returns address currently being used by the instrument.
– STATic - Returns static address from non-volatile memory. This address is used if DHCP is disabled or unavail-
able.
– SYSTem:SECurity:IMMediate sets this parameter to its default value.
– The setting is non-volatile, and does not change when power has been off, after a Factory Reset (*RST) or after
an Instrument Preset (SYSTem:PRESet).
330
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming
To Next Page
Loading...
