Keysight N774xC Series Multiport Power Meter Programming Guide 91
Measurement Operations & Settings 4
Parameters: Integer number between 0-997 (including limits)
Response: None
Example: :trig1:del 10
Command: :TRIGger[n]:INPut?
Syntax: :TRIGger[n]:INPut?
Description: Returns the incoming trigger response.
Parameters: None
Response: IGNore:
SMEasure:
CMEasure:
MMEasure:
PREtrigger:
THReshold:
Ignore incoming trigger
Start a single measurement. If a measurement function is active, see :SENSe[n]:FUNCtion:STATe on
page 80, one sample is performed and the result is stored in the data array,
:SENSe[n]:FUNCtion:RESult? on page 77.
Start a complete measurement. If a measurement function is active, :SENSe[n]:FUNCtion:STATe on
page 80, a complete measurement function is performed.
Defines how many samples ares stored before trigger event.
Not possible to use multiple cycles.
Similar to PRE, but the starting event is minimum and maximum threshold values. If you don't want
both limit, you can write NAN instead of number.
Example: :trig0:inp? -> IGN
Affects: All power meters
Command: :TRIGger[n]:INPut
Syntax: :TRIGger[n]:INPut<wsp><trigger response>
Description: Sets the incoming trigger response and arms the module.
Parameters: IGNore:
SMEasure:
CMEasure:
MMEasure:
PREtrigger:
THReshold:
Ignore incoming trigger
Start a single measurement. If a measurement function is active, see :SENSe[n]:FUNCtion:STATe on
page 80, one sample is performed and the result is stored in the data array,
:SENSe[n]:FUNCtion:RESult? on page 77.
Start a complete measurement. If a measurement function is active, :SENSe[n]:FUNCtion:STATe on
page 80, a complete measurement function is performed.
Defines how many samples ares stored before trigger event.
Not possible to use multiple cycles.
Similar to PRE, but the starting event is minimum and maximum threshold values. If you don't want
both limit, you can write NAN instead of number.
To Next Page
Loading...
Need help?
General
