Troubleshooting
August 2007 6-2 P/N 06-236716-001
006 Low Battery Check battery voltage, must be greater than 20.5 Vdc in the absence
of primary power. When voltage drops as low as 19.5 Vdc, the
charger will disconnect and the outputs will be isolated.
007 Reversed Battery Verify Battery polarity.
008 Detector #1 Open Circuit Look for discontinuity in detector #1 wiring.
Check for missing/incorrect value 5.1K resistor.
009 Detector #2 Open Circuit Look for discontinuity in Detector #2 wiring.
Check for missing/incorrect value 5.1K resistor.
010 Detector #3/Waterflow Open
Circuit
Look for discontinuity in Detector #3/Waterflow wiring.
Check for missing/incorrect value 5.1K resistor.
011 Manual Release Open Circuit Look for discontinuity in manual release circuit wiring.
Check for missing/incorrect value 5.1K resistor.
012 Supervisory #1 Open Circuit Look for discontinuity in Supervisory #1 wiring.
Check for missing/incorrect value 5.1K resistor.
013 Supervisory #2 Open Circuit Look for discontinuity in Supervisory #2 wiring.
Check for missing/incorrect value 5.1K resistor.
014 Invalid Abort Abort station activated in non-alarm condition.
015 Abort Open Circuit Look for discontinuity in circuit wiring.
016 ARC #1 Short Circuit Troubleshoot ARC #1 wiring by breaking-up circuit to isolate the
short.
017 ARC #1 Open Circuit Look for discontinuity in ARC #1 wiring.
Check ARC #1 configuration.
018 ARC #2 Short Circuit Troubleshoot ARC #2 wiring by breaking-up circuit to isolate the
short.
019 ARC #2 Open Circuit Look for discontinuity in ARC #2 wiring.
Check ARC #2 configuration.
020 NAC #1 Short Circuit Troubleshoot NAC #1 wiring by breaking-up circuit to isolate the
short.
021 NAC #1 Open Circuit Look for discontinuity in NAC #1 wiring.
Check for missing/incorrect value 5.1K resistor.
022 NAC #2 Short Circuit Troubleshoot NAC #1 wiring by breaking-up circuit to isolate the
short.
023 NAC #2 Open Circuit Look for discontinuity in NAC #1 wiring.
Check for missing/incorrect value 5.1K resistor.
024 NAC #3 Short Circuit Troubleshoot NAC #1 wiring by breaking-up circuit to isolate the
short.
025 NAC #3 Open Circuit Look for discontinuity in NAC #1 wiring.
Check for missing/incorrect value 5.1K resistor.
026 ARC #1 Not Open Circuit Check configuration to make sure ARC #1 is enabled.
027 ARC #2 Not Open Circuit Check configuration to make sure ARC #2 is enabled.
028 Serial Cable Connected Remove serial cable.
Code Trouble Corrective Action
To Next Page
Loading...
