Appendix C: Applications
P/N 3102351-EN • REV 005 • ISS 28DEC18 225
Notes
• For PS/PD, PHS/PHD, IPHS, and SD detectors configured as “Supervisory Non-latching”
device type or for PCOS/PCD detectors (smoke element) configured as “Smoke
Supervisory Non-latching” device type, if the base is Relay/Sounder, then the follow type
option cannot be configured as “Head.” The follow type in this case should be set to
“Alarm.”
• The following procedure must be done using the Configuration Utility (CU).
To program the sounder base for T3T4 Fire/CO:
1. Set the panel’s Event Notification option to Device/Zone.
2. Configure the detectors as follows:
Message Line 1: DETECTOR_<N>, where <N> can be the device address or other number
Device Type: Primary sensor type + CO alarm
Base Type: SBT/ABDT Sounder
Follow: None, Head, Alarm, Alm + Vrfy, or Alm + PreAlm
Follow CO: No or Yes (only displays if Follow is set to Alarm, Alm + Vrfy, or Alm + PreAlm)
3. Configure the RM1 or CT1 module as follows:
Device type: Monitor
Message Line 1: 24VDC_RISER
Message Line 2: SOUNDER_RLY_1
4. Configure Correlation Group 001 as follows:
Add/Remove Zone: As required
Add/Remove NAC: As required
Add/Remove Device: Add all alarm signal initiating devices corresponding T3T4 device
Channels as described below
To create correlations for T3T4:
1. Channel 1 must be correlated with proper SBT/ABDT sounder base as output to any
primary alarming type inputs.
2. Channel 2 can be correlated with proper SBT/ABDT sounder base as output to secondary
element (CO) of GSA detectors.
3. If both Channel 1 and Channel 2 are correlated as outputs to a sounder base, then
Channel 1 pattern overwrites the Channel 2 pattern.
To Next Page
Loading...
Need help?
General
