Chapter 2: Front panel programming
P/N 3102351-EN • REV 005 • ISS 28DEC18 81
5. Verify the device you are about to delete by reviewing the information on the screen. Before
continuing, be sure that this is the device you want to remove. Once removed, the process
cannot be reversed.
6. Press Enter to delete the device and save the change in the database.
7. Repeat these steps for each device you are removing from the system.
Advanced programming
Overview
Advanced programming lets you program the panel manually and apply custom settings. Most
options have a factory default setting that you can accept or change. See “Factory default
settings” on page 42.
In advanced programming, you can custom program the loop configuration options (loops,
devices, zones, etc.), panel configuration options (annunciators, dialer, network, printer, etc.),
panel operation options (language, marketplace, AC fail delay, etc.), panel events, and loop
events. All of these options can be programmed directly from the front panel.
To do advanced programming, you must have a level two password and it is recommended
that you complete the programming worksheets and have them available before beginning to
program the system. Go to Appendix B “Worksheets” on page 189 to get a copy of each
worksheet.
Note: Before starting the advanced programming sequence, set the time and date, and then
change the default passwords. See “Setting the time and date” on page 59 and “Changing the
passwords” on page 61.
Panel and loop programming options
Advanced programming lets you customize panel operation, panel configuration, and loop
configuration. Programming options include:
Annunciator class programming
Annunciator programming
CMS device programming
NAC programming
Network programming
Network card programming
Loop configuration options include:
Correlation groups programming
Device programming
Loop 2 enable
Loop 3 enable
Loop 4 enable
Panel operation options include:
• Language
• Marketplace
• AC fail delay
To Next Page
Loading...
Need help?
General
