Kinco CD430 - Servo Driver; Technical Specification Table for Servo Driver

108 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

100

11.2 Servo Driver

11.2.1 Technical Specification Table for Servo Driver

Table of Contents

Default Chapter1
- Table of Contents1
Chapter 1 Product Acceptance & Model Description4
Chapter 2 Precautions and Installation Requirements9
Chapter 3 Interfaces and Wirings of CD Driver12
Chapter 4 Digital Operation Panel18
- Introduction18
- Operation on Digital Operation Panel20
  - Example 4-1: Set the Denominator of Electronic Gear Ratio to 10000 with Number System Switching20
  - Example 4-2: Set the Speed to 1000 RPM/-1000 RPM with Separate Regulation of Bits21
Chapter 5 Trial Operation & Parameter Introduction23
- Trial Operation23
- Description of Parameters25
Chapter 6 Operation on Input/Output Ports35
Chapter 7 Mode Operation45
Chapter 8 Control Performance86
- Driver Performance Tuning86
  - Manual Adjustment86
  - Auto Adjustment (Only for Velocity Loops)90
- Oscillation Inhibition92
Chapter 9 Communication94
- Transport Protocol94
- Data Protocol95
  - Download(From Host to Slave)95
  - Upload(From Slave to Host)96
Chapter 10 Troubleshooting97
- Alarm Messages97
- Alarm Causes & Troubleshooting98
Chapter 11 Specification99

Other manuals for Kinco CD430

Manual133 pages

Related product manuals

Preview: Kinco CD420

Kinco CD423-AA-000

Preview: Kinco CD3 Series

Kinco CD3 Series

Preview: Kinco CD2S Series

Kinco CD2S Series

Kinco FD425-LA-000

Preview: Kinco FV100-2S-0004G

Kinco FV100-2S-0004G