the actual bandwidth goes wrong, which
causes abnormal working of the driver.
If the auto tuning result is abnormal,
setting this parameter may also cause
abnormal working of the driver.
Note: This parameter cannot be applied
when auto tuning is unavailable. After
setting this parameter, apply d2.00 to
save the settings as required.
Sets the position loop bandwidth. The
unit is Hz.
Note: After setting this parameter, apply
d2.00 to save the settings as required.
If the variable is set to 11, auto tuning
starts. All input signals are neglected
during auto tuning. The variable is
automatically changed to 0 after auto
tuning is completed.
Sets the variable to other values to end
auto tuning.
To Next Page
Loading...
