90 °C
60 °C
40 °C
Page 20 / 96
7.9. Touchscreen - Section 6: PUR bathing mode, Start/Stop, cabin control,
Green Sauna
Symbol: Display/function:
The cabin control function for operating the controller via the KLAFS Sauna app
is only available for cabins that have WLAN installed and activated.
D For the WLAN function, see page 16.
Cabin control.
D Function for operating the controller via the KLAFS Sauna app, e.g.
with a smartphone.
D KLAFS safety concept ASC.
Performs a visual precheck of the inside of the cabin to ensure that there are no
flammable objects near the sauna heater or the infrared heater. The cabin may
only be started via the KLAFS Sauna app if this visual check has been carried out
after the last sauna session.
D Standby mode. Function for remotely controlling the controller via the
KLAFS Sauna app, see page 28.
Symbol flashing:
The symbol will start flashing after you have pressed the cabin control symbol.
Open the sauna door within the next 30 minutes and check the heaters for
flammable objects, removing any if necessary. The symbol will be permanently
lit after closing the sauna door.
The cabin can now be started via the KLAFS Sauna app.
Symbol permanently lit:
The sauna cabin has been checked.
A bathing mode can be started via the KLAFS Sauna app.
Symbol off:
If the sauna door is opened after the visual precheck and before the session has
started, the symbol will go out. The cabin can no longer be operated via the KLAFS
Sauna app.
If the sauna door is opened during the remote-control standby period and the
cabin temperature is less than 40 °C, the symbol will go out and the controller
must be reset.
If a setting has been changed on the controller or the sauna door has been opened
during the remote-control standby period, the cabin cannot be started via the
KLAFS Sauna app and bathing parameters cannot be changed.
To Next Page
Loading...
