90 °C
60 °C
40 °C
Page 45 / 96
9.8. Interior display (optional), with SaunaPUR Button
Starting the SaunaP
UR bathing mode
D Prerequisite: The temperature must be reached. The symbol
PUR
must be shown on
the display.
D If necessary, start the Sauna bathing mode, see page 31.
D It is possible to start the Sa
UNaPUR bathing mode using the controller or on the interior
display (optional).
1. Press the Saun
APUR bathing mode button.
D If
appears in the seven-segment display, wait until the temperature for the
S
AUnaPUR bathing mode has been reached. Then try again.
D When the Sa
UNaPUR bathing mode is active, the SaunaPUR bathing mode LED lights
up.
D After approximately 20 minutes, or once the temperature in the sauna cabin has
decreased by approximately 15 °C, the Sa
UNaPUR bathing mode stops automatically.
The sauna heater begins heating again.
Stopping the SaunaPUR bathing mode
1. Press the SaunAPUR bathing mode button.
D The Sa
UNaPUR bathing mode LED goes out. The sauna heater begins heating again.
To Next Page
Loading...
