90 °C
60 °C
40 °C
Page 65 / 96
10.3. Setting the bathing time
Risk of fire
Before commissioning the controller, always check that there are no inflammable
objects on or near the sauna heater.
If the slider is at the far left, the selected bathing mode will start immediately.
In preset time mode (start time in the future), the length of the last heat-up phase is
subtracted.
SanariumBathing mode
Bathing time
Temperature
Humidity
70
19:00 - 22:00
22:00
19:00
Bathing time
4
31 2
5
Changing the bathing time
1. Press the Bathing time line (1) to
activate it.
The Bathing time line (1) changes the
background colour.
2. Select "Start time" (2) and use the
+/- buttons or the slider (4) to set
the start time.
3. Select "End time" (3) and use the
+/- buttons or the slider (4) to set
the end time.
D Slider at the far right = maximum
operating time; slider at the far left
= operating time of 1 Minute.
4. Confirm the setting by touching the
screen (5).
D The value is automatically
accepted after three seconds.
Alternatively, this can be done by
tapping on an empty area of the
screen.
To Next Page
Loading...
