90 °C
60 °C
40 °C
Page 47 / 96
9.10. SANARIUM M - Preparing the evaporator
Filling the evaporator
Fill the evaporator when it is cold.
The maximum fill capacity is 9 litres.
Topping up the evaporator
Topping up the evaporator when it is hot:
The temperature difference causes mechanical stress in the tank, which may
become apparent due to a noise when topping up.
Do not put any additives into the water.
1
3
2
1. Close the drain valve (1) - turn the
drain valve to a vertical position.
2. Fill the evaporator's filling unit (2)
with water.
3. Do not overfill the evaporator tank.
Read the filling quantity on the
level indicator (3).
D If the evaporator tank is overfilled,
use the drain valve (1) to drain the
water again.
To Next Page
Loading...
