Kleemann GENIUS20 - Page 140

140
MA06-03-1-01
Menu
Parameter
[Direct access]
Description
Default
value
Value
Range
1.O:position signal
Definition of the first output of the position
signal in the car; 5 successive outputs are
assigned as follows:
IO1: O Drive UP DS1
IO2: O Back up DS1
IO3: O Drive UP DS2
IO4: O Back up DS2
IO5: O Stop DS1 und DS2
Automatic car call
With car lifts with only 2 floors, this parameter
enables the setting of an automatic call to the
other floor. A precondition to this function is the
existence of a presence sensor in the lift car and
the activation of the light curtain during the
process of embarking the lift.
YES/NO
[Direct access: CMD -> 7196]
Parameter
[Direct access]
Description
Default
value
Value
Range
I:Lift boy active
Definition of an input for switching the control
into lift-boy mode. During lift boy mode, landing
calls are not accepted directly but reported to
the lift boy as a request.
1.O:landing call DS1
Definition of the first output of call request for
reporting landing calls on door side 1 to the car.
1.O:landing call DS2
Definition of the first output of call request for
reporting landing calls on door side 2 to the car.
(In case of selectivity)