800+Ok and note the instructions for retracting the aprons
Should the installation be equipped with a holding magnet (HM) for aprons, then an input about the HM’s
retraction will be expected when issuing the output for the HM.
The controller switches into “out-of-order” mode.
- hinged apron folded out even though the HM is supplied with current.
- wiring not correct
- defective input
- retract hinged apron
- in case of automatic folding, please note the operating procedures
If the input should be defective it can be parameterized to another available I/O any time.
800+Ok and note the instructions for retracting the aprons
Apron not activ in normal mode at door 1, because of S chain!
Apron not activ in normal mode at door 1, because of S chain!
If the controller recognizes the S6 input to open during travel, the holding magnet for the hinged apron
deactivates.
The controller switches into “out-of-order” mode.
- S6 has been opened during travel
800+Ok and note the instructions for retracting the aprons
Apron input active in normal mode at door 2!
Under normal operation, the controller expects to receive input about the hinged aprion being retracted.
The controller switches into “out-of-order” mode.
- hinged apron folded out
- wiring not correct
defective input
- retract hinged apron
- in case of automatic folding, please note the operating procedures
If the input should be defective it can be parameterized to another available I/O any time.
800+Ok and note the instructions for retracting the aprons
Apron magnet output door 2 active but no effect on input!
Should the installation be equipped with a holding magnet (HM) for aprons, then an input about the HM’s
retraction will be expected when issuing the output for the HM.
The controller switches into “out-of-order” mode.
- hinged apron folded out even though the HM is supplied with current.
- wiring not correct
- defective input
To Next Page
Loading...