Parameter
[Direct access]
since otherwise, the entire installation stops
before reaching the mounted switch.
If this output is defined, it is activated when
the lift reaches the “speed (mm/s)”
indicated in the following parameter. As
soon as the defined speed returns to a lower
level, the output is deactivated.
With a defined speed limitation output, this
parameter is activated. The value entered
here determines a speed in mm/s which –
when exceeded – marks when the
previously defined output is to be activated.
This parameter defines the distance during
the beginning of the travel which the car is
covering in the wrong direction. This may be
caused eg. by wrongly adjusted inverter
parameters. By entering the 0 value, this
parameter is deactivated.
To Next Page
Loading...